Toshiba e-STUDIO2050C Guide D'installation page 13

19. Remove the screws and take off the cover.
• Screws: 5
* Only for JPD, ASD, ARD, AUD, AUH, TWD
and CND.
20. Loosen the screws and take off the cover.
• Screws: 2
* Only for JPD, ASD, ARD, AUD, AUH, TWD
and CND.
21. Remove the cable as shown in the figure and
connect the connector.
* Only for JPD, ASD, ARD, AUD, AUH, TWD
and CND.
22. Attach the cover and tighten the screws.
• Screws: 2
* Only for JPD, ASD, ARD, AUD, AUH, TWD
and CND.
© 2012 - 2014 TOSHIBA TEC CORPORATION All rights reserved
12 / 21
1
2
e-STUDIO2050C/2550C/2051C/2551C