Without Hand Terminal - Lenze starttec 1 Instructions De Montage

Show/Hide Bookmarks
Commissioning
7

Without hand terminal

)
Note!
Do not change the switch-on sequence.
l
In the event of an error during commissioning please see the chapter "Fault
l
detection and elimination".
Switch-on sequence
1. Ensure that the starttec is inhibited
after mains switch on.
2. Switch on the mains
3. Switch on the 24 VDC supply
4. starttec enable
5. If necessary, release the brake
6. 6.
Start drive
7. The drive should be running now
84
Terminal X3/28 = LOW
Terminal X3/28 = HIGH
Terminal X3/E3 = HIGH
Motor 1 start Terminal X3/E1 = HIGH
CINH CINH CINH CINH CINH CINH
E1 E1 E1 E1 E1 E1
M M M M M M
E3 E3 E3 E3 E3 E3
t ir t ir t ir t ir t ir t ir
EDK71MMXXX-010 DE/EN/FR 2.0
Note
CINH Enable starttec via
X3/28
E1 Motor start
M1 Voltage characteristic at
1U, 1V, 1W (motor 1)
E3 Control of brakes B1, B2
t t t t t t
t if t if t if t if t if t if t Acceleration time
ir
start013
t Deceleration time 0.5 s
if
(C0013)
L