Bus Function Module Connection - Lenze starttec 1 Instructions De Montage

Show/Hide Bookmarks
The starttec can be connected to the following bus systems when using the FIF interface:
Bus system
PROFIBUS-DP
INTERBUS
System bus (CAN)
DeviceNet/CANopen
LECOM-B (RS485)
)
Note!
l
l
(
Stop!
Terminal 28 (controller inhibit) of the function module is not active when using the
starttec. Enable/inhibit is activated vai terminal 28 of the starttec.
L
Mounting of a FIF modules requires the mounting kit E71ZJ001!
– Please read the Mounting Instructions enclosed in the mounting kit.
Information about wiring of the bus function module can be found in the enclosed
Mounting Instructions for the bus function module.
EDK71MMXXX-010 DE/EN/FR 2.0
Electrical installation

Bus function module connection

Required Lenze FIF module
E82ZAFP 001
E82ZAFI 001
E82ZAFC 001
E82ZAFD 001
E82ZAFL 001
5
81