Selve SE Plus Serie Notice De Réglage page 31

Reset
5. Reset
Precondition: Both end positions must be set, this means, the drive does no longer make any
moving interruptions during operation.
Reset with Reset with
switch setting switch
5x 3 s with
1 s pause
Both limit positions already set will be deleted. Start the setting of the end limit positions
once again (4.5.1.).
Drive
Connect the setting switch cable to the motor
wiring cable.
E
Press the E button of the setting switch for
1 s 1 second. Both limit positions already set will
be deleted.
Alternatively: Move the drive upwards until it
stops automatically at the upper limit stop and
performs a short release.
Then press the switch 5 times for 3 seconds
with 1 second pause in upwards direction.
Then turn on the upward direction again. The
motor moves down and switches off automati-
cally. Now turn off the switch.
31
EN