Selve SE Plus Serie Notice De Réglage page 29

Setting of the end positions
4.5.2. Manual setup-mode, deletion and manual setting of the end positions
in operation bottom position, top stop/release
When the movement is interrupted once, the system is in manual setup-mode.
Important: A limit stop for the upper end limit is necessary!
In manual setup-mode, the lower end position must be set and stored first.
Setting with Drive
setting switch
E
6 s
STOP
E
E
3 s
E
STOP
Press the E button of the setting switch for 6 seconds. The
motor will switch to manual setting mode. Both limit positions
already set will be deleted.
Move the motor to the lower end position with the UP or
DOWN button.
Press the E button for 3 seconds.
The correct rotation direction assignment will be carried out at
the end of the end position setting.
Run against the limit stop at the top; the motor stops automati-
cally. The correct direction of rotation assignment has been
made.
Perform a test run: The motor moves up against the limit stop
and relieves shortly.
29
EN