Gong SUP 1 SASU Guide De L'utilisateur page 41

∙ Kite deflation
❶
- Turn the dry kite, extrados facing the ground, leading edge into the wind.
❷
- Remove the neoprene protection and slowly unscrew the lower part of the inflation valve. Take care
not to lose the seal on the plug.
❸
- Position your kite downwind. Put sand or sufficient weight on the windward tip to secure it.
For DISPLAY and other models with One-Pump clamps:
䗂 Open the clamps on the battens.
䗂 Press down on the battens, from the trailing edge to the leading edge, to release the air through
the hoses.
For models with glass fiber battens (Strutless, Strutless REVO) :
䗂 Remove the battens by pulling them out of the sheath by the trailing edge.
❹
- Roll up one end of the kite to the center, squeezing it to release the air from the leading edge. Do the
same from the other end to the center. Fold the two rolls together and fold your kite in 2 or 3 parts,
starting from the trailing edge of the wing.
❺
- Pack the kite in its bag along with its accessories.
41
GONG-GALAXY.COM