ETNA KIF880DS/E01 Manuel D'utilisation page 52

INSTALLATION
Power limiter
Setting the power limiter should only be carried out by a registered and qualified
installer. Please read the safety regulations and the installation instructions
carefully.
The hob is equipped with a power limiter. If the total power of operating cooking zones exceeds
the maximum available amount of power, the power is automatically reduced. The display of the
cooking zone who is being reduced in its power is first flashing; the level is then automatically
reduced to the highest available power.
• The limiter is set at 7400 W by the factory, but it is possible to change it to 1400 W, 2300 W,
3000 W, 3700 W, 4600 W, 6000 W or 10400 W.
Power limiter configuration
Make sure there are no pots or pans on the hob before you start!
1. Disconnect the appliance from the main power supply by removing the power connector
from the socket, by removing the fuse or turning the circuit breaker off.
2. Reconnect the appliance to the power supply.
The keep warm key is flashing.
▷
• Perform, within 2 minutes after reconnecting the hob to the power supply, the
following steps.
• Make sure all cooking zones are switched off.
3. Touch and hold the keep warm key.
4. Now touch each cooking zone key, starting with the middle-front cooking zone button and
proceeding in the anticlockwise direction.
EN 24