Operating With The Remote Keypad; Communication Setup - Analog way Centrix CTX8022 Manuel Utilisateur

CENTRIX™ & EVENTIX™

3-3. OPERATING WITH THE REMOTE KEYPAD

IMPORTANT: The CENTRIX

3-3-1. COMMUNICATION SETUP

• CASE OF RS-232 PORT
Connect the REMOTE KEYPAD to the CENTRIX
3-1. )
Then only power ON all the devices.
Activate the REMOTE KEYPAD RS232 communication port with the LCD of the REMOTE KEYPAD
(CONSOLE > RS232/LAN port > RS232).
• CASE OF LAN PORT
Connect the REMOTE KEYPAD to the CENTRIX
then configure the LAN communication port of the CENTRIX
LCD menu (CONTROL > LAN setup).
Select the LAN communication port of the CENTRIX
RS232/LAN port > LAN).
Connect the LAN port (RJ45 connector) of the CENTRIX
installation.
Connect the LAN port (RJ45 connector) of the REMOTE KEYPAD to your network according to your
installation.
Then configure the REMOTE KEYPAD LAN communication port with the LCD menu (CONSOLE > LAN
setup).
Activate the REMOTE KEYPAD LAN communication port with the LCD menu (CONSOLE > RS232/LAN
port > LAN).
NOTE: If the communication doesn't work (CENTRIX
port to your Remote Keypad, and restart the device. The device will also automatically detect and activate
the RS232 communication port.
3-3-2. OPERATING IN MIXER MODE
• SETTINGS
We recommend resetting the CENTRIX
(CONTROL > default value > yes) before proceeding.
Verify the CENTRIX
Select the input type connected to the inputs with the LCD menu (INPUT > input type).
Select the output sync. type which corresponds to your display device with the LCD menu (OUTPUT > output
sync).
Select the output rate mode with the LCD menu (OUTPUT > output rate).
Select one of the output formats with the LCD menu (OUTPUT > output format).
NOTE: For fixed pixels display device (DMD, LCD, PLASMA...), always select the output format corresponding
to the native resolution of your display device. Thus, the display device will not have to scale the image
and the result will be better.
Select the type of screen (4/3 or 16/9) with the LCD menu (OUTPUT > type of screen > 4/3 or 16/9),
according to your wall mounted projection screen shape.
™
& EVENTIX
MATRIX MODE. The MIXER MODE allows switching seamlessly, fading and titling between all
the inputs. The MATRIX MODE allows to display the inputs onto two independents display devices.
The default mode is the MIXER MODE. To set the device in MATRIX MODE, please refer to the
section: 3-3-3.
™
/ EVENTIX
™
can be used in two different modes: the MIXER MODE and the
™
/ EVENTIX
™
/ EVENTIX
™
/ EVENTIX
™
™
only), you need to reconnect the RS-232 communication
™ ™
/ EVENTIX
™
is set in MIXER MODE with the LCD menu (MODE > mixer mode).
Chapter 3 : OPERATING MODE (continued)
™
according to your installation (see section 2-
™
with the RS-232 port as indicated above,
™ ™
/ EVENTIX with the REMOTE KEYPAD
™
with the LCD menu (CONSOLE >
™
/ EVENTIX to your network according to your
device to its default values, with the LCD menu
PAGE 33