Publicité
Les langues disponibles
Les langues disponibles
-
Connect the TIG torch to the negative
pole of the welder and the gas hose to the
pressure regulator of the gas cylinder.
The flow of the gas is automatically con-
trolled using the knob of welding para-
meters' regulation (6). Use inert gas (ar-
gon ) only.
-
Turn the inverter on.
8.1
WELDING MODE SELECTION
-
Select the welding mode, 4T Lift, 2T Lift,
4T HF or 2T HF using the Welding Mode Se-
lection Knob (4) on the front panel.
-
Your welder allows to activate the Pulse
Function in both 2T and 4T Welding Modes:
•
Select Pulse Mode by acting on the
SET key. The LED (K) will stay on. The
display views "ON" if Pulse Mode is acti-
vated, "OFF" is Pulse Mode is not active.
•
Turn the Welding Parameters' Regu-
lation Knob (6) to change setting.
•
The unit automatically confims
setting after 3 seconds and go back to the
regulation sequence start. Welding Cur-
rent Light (D) is on.
•
The Pulse Light stays on if Pulse Fun-
ction is activated, off if not activated or
MMA Mode is selected.
8.2
TIG WELDING PARAMETERS'
REGULATION
-
Follow the here below steps to know
which are the parameters you can set accor-
ding to the selected Welding Mode.
4T Lift - 4T HF
2T Lift - 2T HF
Start and Crater Current is set at 5Amps as
default.
PULSED TIG
Welding Current:
-
When Welding Mode is selected, Welding
Current Light (D) is on.
-
Set Welding Current through the Welding
Parameters' Regulation Knob (6).
Following welding parameters:
-
Change the possible parameters accor-
ding to the welding modes you are going to
work in by following the here below steps:
•
Press the SET key to select the Light
the
corresponding to the parameter you want
to change. The light corresponding to the
selected parameter stays on.
•
Set the desired value through the Wel-
ding Parameters' Regulation Knob (6).
•
Push again the SET key (K) to con-
firm the set value and proceed with the
welding parameters setting. The unit will
automatically confim the set value after 3
seconds and go back to the welding cur-
rent regulation.
EN-9
Publicité
