Publicité
Les langues disponibles
Les langues disponibles
IMPORTANT
CAREFULLY READ THE FOLLOWING
INSTRUCTIONS BEFORE INSTALLING
THE UNIT AND MAKE SURE THAT THE
YELLOW AND GREEN GROUNDING
CONDUCTOR IS DIRECTLY CONNEC-
TED TO THE GROUND IN THE WELDING
LOCATION./
THE UNIT MUST NEVER BE OPERATED
WITHOUT PANELS AS THIS COULD BE
DANGEROUS FOR THE OPERATOR AND
COULD CAUSE SERIOUS DAMAGE TO
THE EQUIPMENT.
THE UNIT WORKS ONLY WITH INPUT
VOLTAGE OF 230Vac -50 Hz-1Ph.
THE INPUT CABLE IS ENERGIZED EVEN
WHEN THE MAIN SWITCH IS ON THE "0"
POSITION. THEREFORE, BEFORE SER-
VICING THE EQUIPMENT, MAKE SURE
THAT THE 2 POLE PLUG IS DISCON-
NECTED FROM THE LINE SOCKET.
THIS WELDER CAN BE USED ONLY
WITH DIESEL GENERATING SETS WITH
POWER HIGHER THAN 10 KVA AT 220 V
50 HZ.
1.0 INTRODUCTION
1.1 EQUIPMENT IDENTIFICATION
The unit's identification number (specification
or part number) model, and serial number
usually appear on a nameplate attached to
the rear panel. Equipment which does not
have a control panel such as gun and cable
assemblies is identified only by the specifica-
tion or part number printed on the shipping
container. Record these numbers for future
reference.
1.2 RECEIPT OF EQUIPMENT
When you receive the equipment, compare
it with the invoice to make sure it is complete
and inspect the equipment for possible dama-
ge due to shipping. All machines dispatched
have been scrupulously checked. However,
should your machine not work properly, con-
sult the section on TROUBLE SHOOTING in
this manual. If the fault persists, consult your
authorized dealer.
2.0 SAFETY WARNING
2.1 GENERAL INSTRUCTIONS
This manual contains all the necessary in-
structions for:
- the installation of the equipment;
- a correct operating procedure;
- an adequate maintenance of the equipment.
Therefore, be sure this manual is carefully
read and understood by the maintenance
and technical operators.
2.2 LOCATION
Welding processes of any kind can be dange-
rous not only to the operator but to any person
situated near the equipment if safety and opera-
ting rules are not strictly observed.
Therefore the owner and the operator must
be aware of all possible risks so that they
may take the necessary safety precautions to
avoid any kind of accident at work.
The main precautions to be observed are:
-
Operators should protect their body by
wearing non flam-
mable, close fitting
protective
clothing,
without pockets or
turned-up trousers.
Oil or grease should
be carefully removed
from all articles, be-
fore wearing. Ope-
rators should also
wear closed safety
boots with steel toe
caps and with rubber
soles ( Fig. 1).
1. Leather gloves
2. Leather aprons
3. Shoes Cover
4. Security shoes
5. Face mask
According to the requirements
in 2006/25/EC Directive and EN
12198 Standard, the equipment
is a category 2. It makes compul-
Optical Radiation Emission
Category 2
(EN 12198)
sory the adoption of Personal Protective
Equipment (PPE) having filter with a pro-
tection degree up to a maximum of 15, as
required by EN169 Standard.
-
Operators should wear a non- flammable
welding helmet or face shield designed so as
to shield the neck and the face, also on the
EN-1
Fig.1
Publicité
