Olimpia splendid UNICO PRO R32 EVAN Mode D'emploi Et D'entretien page 98

f. Enter the password of the Wi-Fi network you are using, then press on "Next" to
connect the device.
g. Wait for connection of the appliance.
If the connection fails, check that in the name of the Wi-Fi network
and in the Password there are numbers and letters only (no special
symbols); try to perform the points "d", "e" and "f" again.
h. When the appliance is connected, it is possible to rename it and select the room
where it is located.
4.2 - ACCESSORIES B1014 - B1012
In the event of installation of the accessories serial interface B1014 and/or wireless
wall control B1012, during configuration phase it is necessary to deactivate visualiza-
tion on the display from the remote controller (key B10). While using the accessories
B1014 and/or B1012, it is not possible to command the air conditioner neither from
the remote controller nor from the keys on the air conditioner console.
4.3 - MODBUS RTU RS485
The communication port allows the air conditioner to carry out the following functions:
• Send the commands to the air conditioner, exactly as the remote controller.
• Send another temperature of the room to the air conditioner, read by a wall ther-
mostat.
• Read the work status of the air conditioner and configure it.
• Debug the behaviour of the machine.
• Manually command the fan and all the loads of the machine.
4.3.1 - MODBUS RTU RS485 connection
To connect the appliance to the MODBUS
RTU RS485, proceed as described:
a. Open the door on the right side (6).
b. Connect the MODBUS cord (6a) to
the connector (6b).
c. Connect the MODBUS cord (6a) to
the USB cord.
d. Connect the USB cord to a PC.
EN - 42
37
6
6b
6a
6a