Olimpia splendid UNICO PRO R32 EVAN Mode D'emploi Et D'entretien page 82

It is possible to proceed with the electric connection through a cable recessed into
the wall in the position indicated in the installation template (connection advised for
installations of the equipment in the top part of the wall).
To prevent any risk of electro-
cution, it is fundamental to dis-
connect the main power switch
before carrying out electrical con-
nections and any maintenance
operation on the appliances.
To replace the power cord, proceed as
follows:
a. Raise the air intake grille (3) and remove
the two screws (3a) (fig. 25).
b.
Extract the right (unlock with a screw-
driver) and left (1a) doors of the front
cover, then turn the flap (1) and remove
the three screws (1b) and the two
screws (1c) (fig. 26).
c.
Remove the front cover.
d. Undo the two fixing screws (X2) to re-
move the front cover of the switchgear
(X1) (fig. 27).
e. Undo the two fixing screws (X4) to
remove the top cover of the switchgear
(X3) (fig. 27).
f. Unscrew the cable clamp (J1) and the
cable locking screws of the clamp block
(J2) (fig. 28)
g. Extract the cable and insert the new
cable by following the same path.
h.
Lock the three poles of the cable in the
clamp block (J2) and tighten the screws.
i. Lock the cable with the clamp (J1).
l. Close the switchgear.
m. Reassemble the front cover of the
machine.
This operation must be carried
out by specialized personnel
possessing the skills required
by law.
EN - 26
25
3a 3
26
1
1a
1b
1b
1b
27
X1
X2
X2
28
J2
3
3a
1a
1a
1
1a
1c
X3
X4
J1