Publicité
Les langues disponibles
Les langues disponibles
Filter extraction:
a.
Electrically disconnect the appliance.
b.
Switch off the unit and wait for the closure of the suction flap.
c.
Manually raise the air suction grille (3) (fig. 39).
d.
Raise the front part of the filter (F) and slightly pull it towards yourself (fig. 39).
e.
Extract the two additional filters (fig. 40) from the filter group (F):
(green purifying filter ref. F1 - black active carbons filter ref. F2).
f.
Perfectly wash and dry all the filters.
Filter reassembly:
g.
Insert the active carbon filter (black colour) (ref. F2) on the pins located on the
front part of the filter (F) (fig.41b).
h.
Insert the purifying filter (green colour) (ref. F1) on the pins located on the front
part of the filter (F) (fig. 41b).
i.
Reassemble the filters group (F1-F2) inserting the rear edge inside the grid (fig.
42).
l.
Manually close the air suction grille (3).
To cancel the dirty filter report, after having connected the air conditioner to the mains
voltage, press simultaneously, for at least 5 seconds, the keys Stand-by and MODE
located on the command panel (Fig.30). This way, the dirty filter report is cancelled
and the respective counting is reset.
39
3
40
F1
42
EN - 44
min.80
mm
F1
F
F
F2
F
F1
F2
A
F1
F2
F2
41
B
Publicité
