PRO-POINT 9085986 Mode D'emploi page 18

V1.0
Digital Display Meter – Displays current before and during welding,
I
other parameter settings and error message codes.
Voltage Output Type – Select either DC or AC output voltage when in
J
Stick or TIG welding modes.
K Remote Control – Switch current control from the control panel to a
remote device, such as a foot pedal.
L Pulse On/Off Selection Switch - Activate or deactivate TIG pulse.
M Welding Process and 2T/4T Selection Switch – Select either MMA or TIG
welding. Initial TIG setting is 2T. Switch to MMA and back to TIG again to
select 4T. See TIG Torch Trigger Modes in Operations.
N Gas Pre-Flow – A range of 0 to 10 seconds of gas flow before the torch is
ready for welding. This will purge impurities from the gas line.
Pulse Frequency – Set the pulse frequency (pulses per second) when in
O
the pulse welding mode. Adjustment range is 1 ~ 200 Hz.
Background Amps – Set the background current from 10 to 100% during
P
pulse mode only. The current will drop from the set amperage down to
the chosen percentage each pulse cycle.
Q Gas Post-Flow – Set the gas to flow from 0 to 20 seconds after the weld arc
is extinguished to protect the weld zone from contamination while cooling.
Please read and understand all instructions before use. Retain this manual for future reference.
9085986
Fig. 2