Publicité
Les langues disponibles
Les langues disponibles
V1.0
5.
Keep hands away from the electrode and the area it is being applied to
when the tool is in operation.
6.
Do not connect the welding machine ground clamp to an electrical
conduit. Do not weld on an electrical conduit.
7.
Do not touch the electrode or welded surface immediately after use. The
surface will be hot and may cause an injury.
8.
Never use a tool with a cracked or worn electrode. Change the electrode
before using and discard the damaged one.
9.
Remove the electrode from the holder when not in use.
POWER CORD
1.
Insert the power cord plug directly to the power supply whenever possible.
Extension cords are not recommended for use with this welding machine.
Use a welding extension cord designed to exceed the welding machine's
maximum power requirements when an extension cord is required.
2.
Do not operate this tool if the power cord is frayed, damaged or poorly
spliced, as an electric shock may occur, resulting in personal injury or
property damage.
3.
Discontinue use if a power cord feels more than comfortably warm while
operating the tool.
4.
Keep all connections dry and off the ground to reduce the risk of electric
shock. Do not touch the plug or wiring with wet hands.
5.
Prevent damage to the power cord by observing the following:
a.
Place the power cord in a position that prevents it from coming into
contact with the tool or getting caught by the workpiece. The cord
should always stay behind the tool.
b.
Do not pull on the cord to disconnect the plug from an outlet.
c.
Keep the cord away from heat, oil, sharp edges or moving parts.
6.
Do not allow people, mobile equipment or vehicles to pass over unprotected
power cords. Position power cords away from high traffic areas.
a.
Place cords in reinforced conduits or place planks on either side of
the power cord to create a protective trench.
7.
Do not wrap the cord around the tool, as sharp edges may cut insulation
or cause cracks if wound too tight. Gently coil cord and either hang on a
hook or fasten with a device to keep cord together during storage.
Visit www.princessauto.com for more information
AC/DC Inverter TIG/Arc Welder
9085986
15
Publicité
