Mercado Medic REAL 9200 TWIN Manuel D'utilisation page 64

Instructions for use for medical bariatric work chairs
5.3. Electrical functions
Electric models can be equipped with up to two electrical functions, electric height adjustment
and optional electric brake. These can be adjusted in two ways; either using the control button
located under the armrest or with the hand-held controller.
Control button
The control button is a three-position electric control (off, up and down), which can be used
to adjust seat height. If the device is equipped with an electric brake, there is a special control
button with two positions (sleep mode and switch between activated and deactivated) for this.
Seat height
The seat height control button is located under the front
edge of the right armrest, see Figure 5.1.
Adjustment:
1. Press up for upward movement.
2. Press down for downward movement.
Brake
The brake control button is located on the outside under
the right armrest, see Figure 5.2.
Activation and deactivation of brake:
1. A short press activates the brake.
2. A short press on the same button deactivates the
brake.
Hand-held controller
The hand-held controller (optional) is available in two versions, wired controller and wireless
remote control. These are available in models with 1 function or 4 functions. The 1-function
is intended to only control raising and lowering. The 4-function model can control all four
functions. The hand-held controller also has a button lock function, see Figure 5.5.
PLEASE NOTE! The device can only be equipped with two electrical functions. Electric backrest
mechanism and seat tilt are not compatible with this device.
Figure 5.1. Control button for adjusting seat
height.
Figure 5.2. Control button for activation and
deactivation of brake.
16
Configurations and settings
21-08861-EN-04