Télécharger Imprimer la page

Mercado Medic REAL 9200 TWIN Manuel D'utilisation page 54

Masquer les pouces Voir aussi pour REAL 9200 TWIN:

Publicité

Les langues disponibles

Les langues disponibles

Instructions for use for medical bariatric work chairs
2. Getting started
This section is primarily aimed at you as a user of the device. It describes how to prepare
the device for use, adjust the seat height, charge electric models, and how to create good
conditions when moving. For care instructions, see 3. Caring for the device.
If you have any questions about your device or if something unexpected has happened, please
first contact your prescriber or dealer. You can find up-to-date contact details in Section 1.1.
Contact details. You are also welcome to contact us at Mercado Medic.
2.1. Before use
The device is always supplied with a seat,
backrest, armrest and brake. When delivered
from Mercado Medic, the backrest and brake
lever are not yet fitted. These should always
be fitted before the device is first used.
Brake lever
Insert the brake lever into the brake lever
bracket (A), see Figure 2.1. The brake lever
can be placed on the right or left side.
Backrest mechanism
Place the backrest support posts in the
backrest mechanism (B) and set the desired
height level, see Figure 2.1. Tighten all
controls (B).
Armrests
Loosen the armrest controls (C) and set the
desired height and width levels, see Figure
2.1. Tighten all controls (C).
Neck support
If the device is supplied with a neck support,
insert the neck support mechanism into the
backrest bracket (D) and set the desired
height level, see Figure 2.1. Tighten all
controls (D).
Battery
Before first use, the battery in electric
models must be activated and charged. This
is done by connecting the battery charger
to the device's charging socket and to a
wall outlet (E), see Figure 2.1. The charging
socket can be placed in different places
on the device. The most common is that
the device comes with the charging socket
mounted at the rear edge of the left armrest.
Wait until the battery is fully charged before
using the device. This normally takes 2 to 5
hours. When the battery is fully charged, the
LED on the charger lights up green. For other
charging instructions, see 2.3. Charging.
6
Getting started
21-08861-EN-04

Publicité

loading

Ce manuel est également adapté pour:

21-08861-ch