Publicité
Les langues disponibles
Les langues disponibles
finishing
EN
11.8 media installation / removal
WARNING
!
•
Clean the glass media prior to installation. Before applying the cleaned glass, ensure that it is dry.
•
If replacing, use only the replacement glass media available from your local authorized dealer / distributor.
•
Glass media over the burner ports may cause flame lifting and sooting problems. Adjust as necessary.
•
Do not place any media (glass or vermiculite) in or around the pilot opening and/or on the burner ports. This
will interfere with the pilot operation.
Cleaning Glass Media
Glass media may have a fine oil residue that needs to be cleaned prior to installation. Clean the glass with mild
dish soap, drain, rinse thoroughly and dry before placing over the burner.
note:
Do not use more media than what was supplied with the appliance. Do not place media directly onto the burner
(NG models only).
Media should be installed across the burner tray and a small to moderate amount of media placed on the burner
itself and, if necessary, adjusted to achieve a pleasing flame appearance. Never place excessive media on the
burner as this can result in carboning or an unappealing flame characteristic. For smaller units, it is
recommended not to put media on the burner ports themselves as the difference in flame pattern can
be particularly noticeable.
Never place media in the pilot housing or over the pilot. Ensure no glass or media falls into the pilot opening.
If this happens, insert a clean bag into your vacuum cleaner and vacuum out the media. Replacement media can
be purchased from your local dealer / distributor.
Always check that the appliance ignites smoothly across the entire burner to ensure media placement does not
compromise performance. Pay particular attention when using power vents to ensure media placement does not
affect ignition or flame characteristics. Adjust the air shutter according to the table under "venturi adjustment".
Undesirable differences in the flame pattern result from excessive or inconsistent / incorrect placement of media
on the burner.
note:
Do not place media directly over large cluster of ports, see "flame characteristics" section for more information.
60
W415-4127 / B-0 / 03.25.24
Pilot Area
Natural gas illustrated.
Publicité
