Napoleon Tall Linear Vector Serie Manuel D'installation page 40

electrical information
6.0 electrical information
EN
6.1 hard wiring connection
It is necessary to hard wire this appliance.
Permanently framing the appliance with an enclosure, requires the appliance junction box to be hard wired. This
appliance must be electrically connected and grounded in accordance with local codes. In the absence of local
codes, use the current CSA C22.1 Canadian Electrical Code in Canada or the ANSI/NFPA 70-1996 National
Electrical Code in the United States.
6.2 receptacle wiring diagram
Route power supply and optional LHAD kit through the outer firebox to the receptacle mounted on the bottom of
the appliance. For optional LHAD kit installation, please refer to the leaflet provided in the kit.
6.3 in the event of a power failure
If the battery holder/switch is equipped with batteries, the appliance will still have ON/OFF functions during a
power failure. Refer to "operation" section in the Owner's manual when communications between battery holder/
switch and remote have been lost. The battery holder/switch will emit a "beep" sound to confirm programming
has been successful once power is restored.
In most cases, your appliance will operate with simple functions available until power is restored. All other electri-
cal features / accessories will not work during a power failure.
40
W415-4127 / B-0 / 03.25.24
L1
L2
To optional LHAD kit
Power Supply
Cable Connector