Télécharger Imprimer la page

Kärcher BD 70/75 W Classic Bp Pack 80 Ah Li Mode D'emploi page 12

Publicité

Les langues disponibles

Les langues disponibles

6. When transporting in vehicles, secure the device
against slipping and tipping over according to the appli-
cable guidelines.
1.
7. First fit the strap under the waste water tank.
Storage
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during storage.
ATTENTION
Frost
Destruction of the device through freezing water
Drain all water from the device.
Store the device in a frost-free location.
● This device may only be stored indoors.
● Before prolonged storage:
1. Bring the battery/batteries to a charging state between
30% and 50%.
2. Disconnect the charger from the battery connector.
3. Press the button on the battery for 20 seconds to put the
battery into sleep mode.
Button
1
Charge level indicator
2
Battery
3
The LEDs of the charge level indicator all light up and go
out one after the other. The charge level indicator now
no longer responds when the button is pressed briefly.
Note
For devices with multiple batteries, this procedure only
needs to be performed on one battery. The other batteries
take over the sleep mode automatically.
12
DANGER
Inadvertently starting up device
Risk of injury, electric shock
Turn the key-operated switch to "0" and remove the key
before performing any work on the device.
Pull out the charger mains plug.
 Drain and dispose of the waste water and fresh water.
Safety inspection/maintenance contract
You can agree on regular safety inspections or close a
maintenance contract with your dealer. Please seek advice
on this.
2.
ATTENTION
Incorrect cleaning
Risk of damage.
Do not spray the device with water.
Do not use aggressive detergents.
A detailed description of the individual maintenance work
is provided in Chapter Maintenance work.
 Drain the waste water.
 Rinse the waste water tank with clear water.
 Clean the exterior of the device using a damp cloth, wet-
ted with a mild washing lye.
 Check the fluff filter and clean if required.
 Clean the coarse dirt sieve.
 Clean the suction lips, check for wear and tear and re-
adjust or replace if necessary.
 Check the disc brushes for wear and tear and replace if
necessary.
 Charge the battery.
 If the charging state of the battery is below 50%,
charge the battery fully and without interruption.
 If the charging state of the battery is above 50%, only
recharge the battery if the entire operating duration
will be required when next used.
A detailed description of the individual maintenance work
is provided in the chapter "Maintenance Work".
1. Drain the fresh water tank and flush out deposits.
2. Clean the fresh water filter.
3. Clean the float and fluff filter.
4. Check battery poles for oxidation, brush off if necessary.
Make sure the connection cables are firmly in place.
5. Clean the seals between the waste water tank and the
cover, check for leaks and replace if necessary.
6. For a longer downtime, shut down the device when the
battery is fully charged. Fully charge the battery at least
once a month.
 Have the prescribed inspection performed by Customer
Service.
Turn over or replace the worn suction lips
The suction lips must be turned over or replace when they
have worn down to the wear mark.
English
Care and service
Maintenance intervals
Each time after use
Monthly
Annually
Maintenance work

Publicité

loading