Migatronic PI 200 DC HP Manuel D'instructions page 21

Trigger mode
Selection of trigger mode. Four-times trigger
mode is active when the LED is illuminated,
and two-times trigger mode is active when the LED is
turned off. It is not possible to change trigger method
during the welding process.
Two-times
The welding process begins by pressing the torch
trigger. Welding continues until the trigger is released
again which effects the slope-down period.
Four-times
The welding process begins by pressing the torch
trigger. If the torch trigger is released during the slope-
up period welding continues with the adjusted welding
current. In order to stop the welding process the
trigger must be pressed again for more than 0.5s after
which the slope-down period begins. The slope-down
period can be stopped by releasing the trigger.
Thereafter the post-flow starts.
It is possible to configure the machine to work in 3
different ways when this mode is selected. For
detailed information read the section "USER MENU" of
this manual about "4t.o."
Anti-freeze
This machine is provided with an anti-freeze control.
The anti-freeze-control reduces the current when the
electrodes stick to the weld piece. This makes it easier
to break off the electrode and welding can continue.
Reset
It is possible to recall all factory standard parameters.
In this case all programs in the machine will be reset
to the following value:
•
MMA current 80A
•
TIG Current 80A
•
TIG Spot Current 80A
•
Pre-flow 0.0 sec
•
Post-flow 6.0 sec
•
No slope-up/slope-down
•
Start amp 40%
•
Stop amp 20%
•
Second Current level 50%
•
Base amp 40%
•
Fast pulse frequency 49Hz
•
Pause time = Pulse time = 0.1 sec
The Reset procedure is as follows:
Switch off the machine and wait until display is
extinguished.
Press the following
simultaneously:
Switch on the machine and keep the above keys
pressed until the display shows "X.XX". Then release
the keys.
X.XX is the software version of program.
key pads
USER MENU
This menu is intended to permit advanced
settings and controls of machine.
To access the user menu, press the knob
seconds when the machine is not welding, MMA or
TIG mode. Rotate the encoder to point the desired
option and activate the selection by pressing "A".
To change the values of parameters press the knob
MMA and rotate the encoder. Press "A" to save the
data.
21
for 3