EN
2.3.4. Recording the RTS control point
The motorisation is in programming mode:
Quickly press the PROG button on the RTS control
point to be programmed:
The motorised product moves up and down: this RTS control point is
programmed in the motorisation.
͉
If the motorisation is no longer in programming mode, repeat Step 2.3.1.
Programming the RTS control point then perform Step 2.3.4. Recording
the RTS control point.
2.4. TIPS AND ADVICE ON INSTALLATION
2.4.1. Questions about the drive?
Observations
The motorised product
does not operate.
20
Possible causes
There may be some
radio interferences.
One or more batteries
have been mounted
backwards.
One or more batteries
leak in the battery tube.
Batteries (inside battery
tube) are weak.
The control point battery
is weak.
The control point is not
compatible.
The control point
used has not been
programmed into the
motor.
Copyright
2021 SOMFY ACTIVITES SA, Société Anonyme All rights reserved.
©
Tilt & Lift 25 RTS
PROG.
Solutions
Unplug the motor sup-
ply cable and reconnect
the battery to the motor.
Verify that batteries
are all mounted in the
correct manner.
Replace the batteries.
Check whether the
batteries are weak and
replace if necessary.
Check whether the bat-
tery is weak and replace
it if necessary.
Check for compatibility
and replace the control
point if necessary.
Use a programmed
control point or program
this control point.