Publicité
Les langues disponibles
Les langues disponibles
EN
2.1.3. Motor and shaft locking
1) Using the relevant tool, pinch headrail edges
to block motor translation.
2) To lock the shaft, place stop rings against the
CTS , and screw them.
2.2. WIRING
Danger
• Cables which pass through a metal wall must be protected and
isolated using a sheath or sleeve.
• Attach cables to prevent any contact with moving parts.
• Drive cable cannot be removed. If it is damaged, return the
drive to the After-Sales department.
• To ensure electrical safety, this Class III motor must be powered
by a «SELV» voltage source (Safety Extra Low Voltage).
Attention
• Leave the motor power supply cable accessible: it must be
possible to replace it easily.
• Do not unplug the battery or the power supply when the motor
is working.
Plug the battery or the power supply with the
motor supply cable.
2.3. COMMISSIONING
2.3.1. Programming the RTS control point
Press the Up and Down buttons simultaneously
on the RTS control point: the motorised product
moves up and down and the control point is
preprogrammed in the motor
18
Copyright
2021 SOMFY ACTIVITES SA, Société Anonyme All rights reserved.
©
Tilt & Lift 25 RTS
1 1
2 2
Publicité
