SOMFY Tilt 25 RTS Notice page 19

Tilt & Lift 25 RTS
2.3.2. Checking the direction of rotation
Press the Up button on the RTS control point:
a) If the motorised product rises (a), the direction
of rotation is correct: Move onto the section
2.3.3. Setting the end limits.
b) If the motorised product lowers (b), the direction
of rotation is incorrect: Move onto the next step.
b1) Press the my button on the RTS control
•
point until the motorised product moves
up and down: The direction of rotation has
been modified.
b2) Press the Up button on the RTS control point to check the direction
•
of rotation.
2.3.3. Setting the end limits
͉
The end limits can be set in any order.
Attention
Do not set the upper end limit in a position in which the fabric or
slats are fully pressed against the headrail, as this could damage
the motorised product and/or the motor in the long term.
1) Bring the motorised product to the down
desired position by pressing the Down button.
2) Press the my and Up buttons at the same
time until the motorised product moves. The
lower end limit is memorised.
3) Press the my button when the motorised
product reaches the desired upper position.
If necessary, adjust the position of the moto-
rised product using the Up and Down buttons.
4) Press the my and Down buttons at the same
time until the motorised product moves. The
upper end limit is memorised. The motorised
product goes down and stops at the lower end
limit.
5) To confirm the end limits, press the my button until the motorised product
moves up and down. The end limits are programmed.
Copyright 2021 SOMFY ACTIVITES SA, Société Anonyme All rights reserved.
©
a
a
=
=
b
b
=
=
b1 b1 b2 b2
1 1 2 2
3 3 4 4
5 5
EN
19