Calpeda NCE EI Serie Instructions Pour L'utilisation page 12

IST NCEEI_Rev100000262_01_1parte.qxp_Layout 1 19/09/23 08:51 Pagina 12
- The type and section of the power cable (chapter 6.5).
- The type of electrical protection to be installed (chapter 6.5).
1.1 Symbols
EN
To improve the understanding of the manual, below are indicated the symbols used with the
related meaning.
Information and warnings that must be observed, otherwise there is a risk that the
machine could damage or compromise personnel safety.
The failure to observe electrical information and warnings, could damage the machine
or compromise personnel safety.
i Notes and warnings for the correct management of the machine and its parts.
Operations that could be performed by the final user. After carefully reading of the
instructions, is responsible for maintenance under normal conditions. They are
authorized to affect standard maintenance operations.
Operations that must be performed by a qualified electrician. Specialized technician
authorised to affect all electrical operations including maintenance. They are able to
operate with in the presence of high voltages.
Operations that must be done performed by a qualified technician. Specialized
technician able to install the device, under normal conditions, working during
"maintenance", and allowed to do electrical and mechanical interventions for
maintenance. They must be capable of executing simple electrical and mechanical
operations related to the maintenance of the device.
Indicates that it is mandatory to use individual protection devices.
Operations that must be done with the device switched off and disconnected from
OFF
the power supply.
Operations that must be done with the device switched on.
ON
1.2 Manufacturer name and address
Manufacturer name: Calpeda S.p.A.
Address: Via Roggia di Mezzo, 39
36050 Montorso Vicentino - Vicenza / Italia
www.calpeda.it
1.3 Authorized operators
The product is intended for use by expert operators divided into end users and specialized
technicians. (see the symbols above).
i
It's forbidden, for the end user, carry out operations which must be done only by
specialized technicians. The manufacturer declines any liability for damage
related to the non-compliance of this warning.
Page 12 / 96 NCE Rev. 100000262_01 - Operating Instructions