Instrument Settings - Julabo PURA 4 Mode D'emploi

Initial operation
Pos : 21 /=== Arc hi v/=== Archi v_War nhinweise/Hinweis: Kondens atbildung an Entlüftungsbohrung @ 1\mod_1551369368077_18.doc x @ 13934 @ @ 1
Pos : 22 /=== T echnisc he Dokumentation/C ORIO / D YN EO / MAGIO / PUR A/PURA LT /Ei nstellmenü @ 1\mod_1464089385799_18.doc x @ 9742 @ 2 @ 1

21.1 Instrument settings

Setpoint
adjustment
Example:
Timer setting
Condensate formation due to steam escaping when bath
cover is fitted!
Steam can escape through the vent holes and cause condensation to form in
the direct vicinity of the water bath.
Ensure sufficient distance between the water bath and adjacent devices

and equipment
Do not close vent holes

Switch on the device -> Display
Press key -> display of actual temperature
The temperature setting can be set when the device has been
started or stopped.

The set value is saved so that it will be retained even after a
power outage.
Adjusting setpoints
1. Press the edit key
the actual value to the setpoint. The decimal point will flash.
2. Change the value:
Press the
Press the
Press the key briefly for single steps. Press and hold the key to
adjust the values quickly.
3. Save the set value as the desired value by pressing the
key.
4. The new setpoint will flash two times.
A signal sounds at 0.5°C before the setpoint is reached.
Setting the timer
7. Press
8. Press key
9. Press
10. Press the
11. Use the
12. Confirm with
OFF
or briefly to switch from displaying
key to set a higher value.
key to set a lower value.
key, "T" flashes
or key
key
key
or key to set h.m
key, timer starts ("T" lights up).
28. 5
OFF
On
run
45