Kenwood Professional PM400 Mode D'emploi page 13

KENWOOD PM400
troubleshooting
problem
The whisk or K-beater knocks against the bottom of the bowl or isn't
G
reaching the ingredients in the bottom of the bowl.
solution G Adjust the height. Here's how:
Unplug.
1
Raise the mixer head and insert the whisk or beater.
2
Hold it, then loosen the nut
3
Lower the mixer head.
4
Adjust the height by turning the shaft. Ideally the whisk/K-beater should
5
be almost touching the bottom of the bowl
Raise the head, hold the whisk/K-beater and tighten the nut.
6
power interruption
Your mixer incorporates a safety device and if there is a power cut or
the appliance has been switched off at the power socket, it will be
necessary to restart the mixer by pressing the green start button. It is
advisable to re-check the desired speed setting before pressing the
green start button.
11