SICK GTB20 Manuel D'utilisation page 28

OPERATING INSTRUCTIONS
2 Safety information
2.1 General safety notes
en
2.2 Intended use
2.3 EMC statement
2.4 Qualification of personnel
28 O P E R A T I N G I N S T R U C T I O N S | GTB20
Instructions to action
The arrow denotes instructions to action.
►
1. The sequence of instructions is numbered.
2. Follow the order in which the numbered instructions are given.
✓
The tick denotes the results of an action.
Connection, mounting and configuration of the product must only be car‐
ried out by qualified personnel.
This product does not constitute a safety component as defined in the
NO
Machinery Directive.
2006/42/EC
SAFETY
Do not install the product in places exposed to direct UV radiation (sun‐
light) or other weather conditions.
The product must be adequately protected against moisture and contami‐
nation.
The GTB20 is an opto-electronic photoelectric proximity sensor (referred to as "sensor"
in the following) for the optical, non-contact detection of objects, animals, and persons.
If the product is used for any other purpose or modified in any way, any warranty claim
against SICK AG shall become void.
NOTICE
Gxx20x-QKxxxxF, Gxx20x-QKxxxxG are compliant with Class A. In a residential environ‐
ment this equipment may cause radio interference, in which case the user may be
required to take adequate measures.
All other Gxx20x-... devices correspond to Class B.
Any work on the product may only be carried out by personnel qualified and authorized
to do so.
Qualified personnel are able to perform tasks assigned to them and can independently
recognize and avoid any potential hazards. This requires, for example:
• technical training
• experience
•
knowledge of the applicable regulations and standards
8026846.1LP5/2024-05-06 | SICK
Subject to change without notice