Publicité
Les langues disponibles
Les langues disponibles
Put the device in place and wait two to three hours before turning it on
for the first time to let stand the system. Do not place it near a heat
source such as a stove, furnace or direct exposure to sunlight, etc.
Leave a space of at least 10 cm above and to each side of the machine
and between the rear of the unit and the wall in order to allow adequate
ventilation. This device is not designed for recessed installation (
"dressing with the attachment structure").
Install it on a firm surface. Any irregularities at ground level must be
corrected before installation. A slight unevenness can be compensated
by adjusting the front feet.
V.
• This device is designed to operate at an ambient temperature
ranging from 10 ° C to 38 ° C. If the temperature goes beyond these
values, ie if it is lower or higher, the camera does not work properly.
If the ambient temperature is above this range for extended periods,
the temperature of the freezer compartment will rise above - 18 ° C,
and food may be spoiled.
• Remove all packaging materials from the unit. Clean the inside of
each compartment with warm water and sodium bicarbonate (5 ml
for each 0.5 liter of water). Carefully dry the camera.
• At the first use of the freezer or after defrost, set the thermostat
switch to the high position for at least 2 hours before placing any food
to be frozen and then adjust the thermostat to the normal position.
• In case of power outage, do not open the door. Frozen food should
not be affected if the failure lasts less than 12 hours.
IV. INSTALLATION
INSTRUCTIONS TO USE
EN-16
Publicité
