Yamaha mLAN8E Mode D'emploi page 18

Settings on the device in which the mLAN8E is installed
•
mLAN8E output settings
(1) Turn knob [A] to select the output source mLAN plug of the mLAN8E.
NOTE
NOTE
NOTE
(2) Turn knob [C] to select an mLAN device on the mLAN bus (system). The upper line will show
the vendor name, and the lower line will show the module name.
(3) Turn knob [1] to select the mLAN input plug of the connected mLAN device, and press the
[ENTER] key. The connection will be executed, and the "New" indication will change to a
number.
NOTE
NOTE
18
You can turn knob [B] to check up to 62 Connection numbers for destination
mLAN devices.
If no previously-specified connection destinations are found, the display will
indicate "*****".
If the connection has not been established, "New" will be displayed above
knob [B], and "[ENTER] toCnct" will be displayed above knob [2].
If the connection has already been established, the current connection des-
tination will be displayed. Also, "[ENTER] To Cut" will be displayed above
knob [2]. In this case, pressing [ENTER] will cut the connection.
To change an existing connection, you must first break the connection and
then specify a new connection.
If the names (vendor name, module name, mLAN plug name) of the con-
nected device exceed eight characters, only the first eight characters will be
displayed.