Yamaha mLAN8E Mode D'emploi page 14

Settings on the device in which the mLAN8E is installed
Before the Word Clock Mode is selected or after SET is executed, this will indicate the current
Word Clock Mode. The display has the following significance.
• Auto(Int): Operating in Auto Mode on the internal clock
• Auto(Ext): Operating in Auto Mode as a slave
• ---(Int): Operating in Manual Mode on the internal clock
• ---(Ext): Operating in Manual mode as a slave
[ press] SET (finalize word clock)
Finalize the selected Word Clock Mode setting.
Knob 4
Nickname (display only)
Displays the Nickname of the A5000/A4000.
[ press] Rename
Set the Nickname.
Knob 5
[ turn] MIDI Input (MIDI Input selection)
NOTE
NOTE
Setting
MIDI IN:
mLAN->A: MIDI messages from the mLAN MIDI input will be sent to the MIDI IN-A port. MIDI mes-
mLAN->B: MIDI messages from the mLAN MIDI input will be sent to the MIDI IN-B port. MIDI mes-
mLAN:
14
Regardless of this setting, the same MIDI output data is sent from both MIDI
OUT and mLAN MIDI.
Regardless of this setting, the MIDI THRU connector will re-transmit the data
that was input to MIDI IN.
MIDI messages input from the MIDI IN connectors will play the A5000/A4000; mLAN will
not be used.
sages from the rear panel MIDI IN-A connector will not be input (A5000 only).
sages from the rear panel MIDI IN-B connector will not be input (A5000 only).
MIDI messages from the mLAN MIDI input will be input to the MIDI IN port. MIDI mes-
sages from the rear panel MIDI IN connector will not be input (A4000 only).