Chicco BI-SEAT Mode D'emploi page 60

Installation
Built-in harness sys-
40-105 cm (rear-fac- tem + Full 360 i-Size
ing) base with Support
Leg
Built-in harness sys-
76-105 cm (for- tem + Full 360 i-Size
ward-facing) base with Support
Leg
Isofix
+ the car's 3-point
100-150 cm safety belt or just
the car's 3-point
safety belt
Use of the "Full 360 i-Size base" is mandatory in the 40-105 cm
configuration. Use of the base is forbidden in the 100-150 cm
configuration.
The Full 360 i-Size base may be included in the package or it may be
purchased separately as an accessory.
1. 40-105 cm (Max 17.5 kg) "Integral Universal ISOFIX "i-Size""
- installation with Full 360 i-Size base and Support leg
rear-facing (see illustrations from number 4 to 18)
connectors
The reducer cushion must be used from 40 cm to 60 cm. The reducer
cushion is included in the package or may be purchased separately
as an accessory.
Reducer cushion
From 40 cm to 60
cm
> 60 cm
!
FOCUS AREAS
a) Do not use the car seat without the base before 100 cm!
b) Installing the car seat in the rear-facing position is mandato-
ry up to 15 months.
c) It is mandatory to use the maximum recline position for a
child up to 75 cm.
d) Installation must be carried out on seats equipped with the
Isofix System.
e) The child must not weigh more than 17.5 kg.
f ) During installation with the Isofix system, the vehicle safety
harness must not be fastened behind the child car seat, as
this would engage the inflatable portion of the safety har-
ness.
g) Use of the reducer cushion (included or available for pur-
chase separately) is mandatory up to 60 cm. Starting from 61
cm the reducer cushion is no longer necessary.
60