Instructions For Use; Placement Tool; Electrical Connection; Generator Start - stayer GID1000 Instructions D'emploi

- Limit length of extension cables: 60m for cables of
2
1.5mm and 100m for cables of 2.5mm .
- Keep the generator away from other electric cables
or wires such as distribution network.
- The DC receptacle can be used while the AC power
is in use. If you use both at the same time, be sure
not to exceed the total power for AC and DC.
- Most appliance motors require more than their rated
wattage for start-up.

3.Instructions for use

3.1 Placement Tool

For your own safety, read this manual and the
general safety instructions carefully before
using the appliance. Your power tool should only
be given to other users together with these
instructions.
Be sure to check the generator on a level surface
with the engine stopped.

3.2 Electrical connection

AC applications
Start the engine and make sure the output indicator light 10
(green) illuminates or dial 230 voltmeter (
GAV2800, GAV5500E, GAV7500E
Confirm that the appliance to be used is switched off, and
plug in the appliance.
Substantial overloading that continuously lights the
overload indicator light (red) 9 may damage the generator.
Marginal overloading that temporarily lights the overload
indicator light (red) may shorten the service life of the
generator.
Be sure that all appliances are in good working order before
connecting them to the generator. If an appliance begins to
operate abnormally, becomes sluggish, or stops suddenly,
turn off the generator engine switch immediately. Then
disconnect the appliance, and examine it for signs of
malfunction.

3.3 Generator start

Start engine according to "Operating instructions".
Confirm that the equipment to be used is switched off, and
insert the plug of the equipment to be used into the AC
receptacle unit A.
Check that the equipment to be connected is switch off.
When the equipment to be used is switched on, it will
operate suddenly, and injuries or accidents may be
caused.

3.4 Output Indicators and overload

The output indicator light 10 will remain lighted during
normal operating conditions.
When the output indicator light (green) does not
light and the overload indicator light (red) lights.
ENGLISH
23
2
GID1000,
).
23
If the generator is overloaded or if there is a short in the
connected appliance, the output indicator light (green) will
go OFF, the overload indicator light (red) will go ON and
current to the connected appliance will be shut off.
Stop the engine if the overload indicator light (red) switches
ON and investigate the overload source.
Before connecting an appliance to the generator,
check that it is in good order, and that its
electrical rating does not exceed that of the
generator. Then connect the power cord of the
appliance, and start the engine.
Connect the ground terminal according to the regulations in
force.

3.5 Battery charging

When using the DC output 15, turn Smart Throttle to the
OFF position. The DC current will be below 5A if turning on
the Smart Throttle without AC current output.
When charging batteries, person must be present
to monitor the voltage.
Stop charging when the voltage of the batteries is above
14.4V. Or it may cause battery explosion, resulting in
serious injury or death.
To prevent the possibility of creating a spark near the
battery, connect charging cable first to the generator, then
to the battery. Disconnect cable first at the battery.
Before connecting charging cables to a battery that is
installed in a vehicle, disconnect the vehicles grounded
battery cable. Reconnect the vehicle's grounded battery
cable after the charging cables are removed. This
procedure will prevent the possibility of a short circuit and
sparks if you make accidental contact between a battery
terminal and the vehicle's frame or body.
Do not attempt to start an automobile engine while the
generator still connected to the battery. The generator may
be damaged.
Connect the positive battery terminal to the positive
charging cord. Do not re-verse the charging cables, or
serious damage to the generator and/or the battery may
occur.
The battery gives off explosive gases; keep spark, flames
and cigarettes away. Provide adequate ventilation when
charging.
The battery contains sulphuric acid (electrolyte). Contact
with skin or eyes may cause severe burns. Wear protective
clothing and a face shield.
If electrolyte gets on your skin, flush with water.
If electrolyte gets in your eyes, flush with water for at least
15 minutes and call a physician. Electrolyte is poisonous.
If swallowed, drink large quantities of water or milk and
follow with milk or magnesia or vegetable oil and call a
physician.