KBS Gastrotechnik Olitrem Marecos HORECA Serie Mode D'emploi page 48

EN
6. REVERSING THE DIRECTION OF THE DOOR
Instructions applicable to models ARV 36, ARV 66, ARV 150, ARV 350, ARV 450 in
all versions, and in the opaque door models ACE 66, ACE 150, ARV 400, ACE 400,
ASP 400, ARV 430, ACE 430, AP 600, MM5, ATP 500, ATG 600 and AGP 700. For
other models, the change must be made at the factory.
The equipment must be disconnected from the mains. Unscrew the top cover or
bottom grill, removing the two screws on the front and rear or bottom and top.
Pay attention to the connections of the digital thermostat, so that they do not
become disconnected.
Remove the bottom bracket from the door and loosen the door's top spring using
a star screwdriver and an Allen key 10mm.
Remove the door and turn it 180º. Reapply the spring hinge and the bearing so that
there is enough spring pressure to close the door.
Tighten the spring on the top bracket and tighten the lower bracket. The handle
should be inserted into the existing holes.
Adjust the door so that it has a correct seal. Confirm that the connections of the
digital thermostat remain connected properly and close the top cover.
7. REPLACEMENT OF LIGHTING (applicable Models)
LED lights, with power equal to 12W/m. 12V DC power supply.
This operation must be carried out by the manufacturer, authorized
representatives, or qualified personnel in order to avoid danger.
47