GYS WF 50 Mode D'emploi page 23

User manual
DESCRIPTION OF THE EQUIPMENT (II)
1- Reel support Ø 200/300 mm
2- Switch for Wire inching - purging
3- Wire-feed motor
4- Cover for coolant outlet (Blue)
5- Cover for coolant inlet (Red)
6- Optional cover for Push-Pull torch interconnections
7- Euro connector (torch)
8- HMI (Human Machine Interface)
9- Screen protection
HUMAN-MACHINE INTERFACE (HMI)
Please read the Interface User Guide (HMI) which forms part of the complete product literature.
HMI
POWER SWITCH
This equipment has been designed to work exclusively with the power sources in the KRONOS / NEOMIG-i range :
KRONOS 400T DUO 075337
KRONOS 400T G 075054
KRONOS 400T GW 075061
NEOMIG-i 400 G 075085
NEOMIG-i 500 G 075092
The connection between these two parts is made through a dedicated interconnection cable, available separately:
Type of torch cooling
Air
Water
ATTACHING THE INTERCONNECTION CABLES
Make sure the main welding power source switched off when connecting or disconnecting the wire feeder. Ensure the machine is
unplugged from the mains, and then wait 2 minutes.
For attaching the interconnection cable between the power source and the wire feeder, refer to pages 3 or 4.
SETTING UP THE REEL
a b
b
a
Translation of the original
instructions
Length Section
5m 70mm²
70mm²
10m
95mm²
1.8m 70mm²
5m 70mm²
70mm²
10m
95mm²
- Remove the nozzle (a) and contact tube (b) from your MIG/MAG torch.
- Open the wire feeder cover.
- Position the reel on its holder.
- Take into consideration the reel stands's drive lug (c). To fit a 200 mm reel, tighten the
plastic reel holder (a) to the maximum.
c
- Adjust the brake wheel (b) to prevent the non-moving spool from tangling the wire when
the welding stops. Do not over tighten as this will cause the power source to overheat.
10- USB connector
11- Torch support
12- Interconnection cable connector
13- Gas inlet
14- Power relay connector
15- Interconnection support
16- Transport handles
17- Turret (pivot)
Reference
075443
075450
077553
075467
075474
075481
075504
WF 50
23