GYS WF 50 Mode D'emploi page 121

Settings (user)
Display mode
- Easy: Reduced display and functionality: no access to the welding cycle.
- Expert: full display, allows the user to adjust the timing of the different welding cycle phases.
Language
Choice of the interface language (French, English, German, etc).
Units of measurement
Choice of measurement units: International (SI) or Imperial (USA).
Name of materials
European standard (EN) or American standard (AWS).
Luminosity
Adjusts the brightness of the interface screen (setting from 1 (dark) to 10 (very bright)).
User code
Customise the user's access code to safely lock the machine (default 0000).
Tolerance I (current)
Current setting tolerance:
OFF: free setting, the current setting is not limited.
± 0A : no tolerance, current limitation.
± 1A> ± 50A : setting range where the user can adjust the current.
Tolerance U (voltage)
Voltage setting tolerance:
OFF: free setting, the voltage setting is not limited.
± 0.0V : no tolerance, voltage limited.
± 0.1V> ± 5.0V : setting range where the user can vary the voltage.
Tolerance (wire speed)
Wire speed setting tolerance (m/min):
OFF: free setting, the wire speed setting is not limited.
± 0.0m/min : no tolerance, wire speed limited.
± 0.1m/min> ± 5.0m/min : setting range at which the user can vary the wire speed.
System (Admin)
Device name:
Device name information and customisation options.
Clock:
Setting the time, date and format (AM/PM).
Cooling unit (only for machines equipped with a cooling system)
- OFF: the cooling unit is deactivated.
- ON: the cooling unit is permanently active.
- AUTO: automatic operation (activates during welding and deactivates 10 minutes after the end of welding)
PURGE : function specifically dedicated to the purging of the cooling unit or filling of the hoses, the protections
are disabled (see the general instructions for safe purging of your product).
17