Tunturi Cardio Fit V20 Manuel De L'utilisateur page 8

GB
Attach seat to base frame
To attach the seat to the base frame it is required to first open the
seat surface caps to free the seat handle fixing pockets�
Position the seat over the pockets, and push it in to secure the fixture�
When removing the seat again from the base frame, pull out the seat
while preventing the base frame from being lifted�
Make sure the seat handle fixing pockets are closed with the surface
caps when seat is not fitted�
‼
NOTE
• The fix will not be a tight fit, therefore the attached seat cannot
be used as a product handle to lift the machine�
The seat can be used for different variations in your workout�
Console
Name and Function of controller
Power:
Press the button while power plug in, LCD shows "00" "10" ,the
machine is toggling between "On mode" and "Standby mode"�
Mode
Press auto program button, to start a pre programmed profile "P1,
P2, P3" quick�
(Start/ Pause)
- Press the button to start the vibration plate�
- In the operation of the machine, press this button to stop working�
(speed +)
Speed increase: Manual 1- 30� (±1)
- Press this button to increase the speed when the machine is
operating�
(speed -)
Speed decrease: Manual 1- 30� (±1)
- Press this button to decrease the speed when the machine is
operating�
(time +)
Time increase:
The default working time is 10 Minutes, divided into 10 levels�
Press this button to Increase time� ( ± 1 minute )
(time -)
Time decrease: the default working time is 10 Minutes, divided into
10 levels�
Press this button to Decrease time�
Function
Control the three major functions of the vibration plate�
- Oscillation
- Vibration
- Oscillation/ Vibration combination
‼ NOTE
• The effective reception range of the remote Control signal is 2�5
meters, the infrared emission indicator of the controller should
be aligned with the infrared receiving window on the vibration
plate�
Remote control
The remote control comes without batteries, and needs to be
purchased and installed prior to use�
The remote control requires 2 pcs� of AAA size batteries�
To fit/ Replace the batteries
- Remove the cover�
Located on the back side�
- Remove the old batteries�
Only valid when replacing the batteries for fresh ones�
- Insert the new batteries�
Make sure that batteries match the (+) and (-) polarity markings�
- Mount the cover�
‼ NOTE
• Empty batteries should always be recycled per your Local legal
regulations to save the environment�
⚠ WARNING
• Do not expose batteries to big temperature changes to prevent
the batteries from leaking�
• To prevent your batteries from leaking, take them out if you plan
on not using your device for longer periods of time�
• When inserting multiple batteries into a device, always use the
same brand, the same type, and the same energy level�
Button functions
The button functions for the remote control are corresponding
with the main unit display buttons, and therefore have the same
functionality�
The Remote control works on an infrared protocol�
Therefore it requires an unblocked air space between remote control's
transmitter and console receiver for proper functionality�
Explanation Display functions
Speed
- Displays current training vibration frequency setting�
- Range: 1 ~ 30�
‼ NOTE
Speed level Motor RPM
Speed 1 430
Speed 2 440
Speed 29 710
Speed 30 720
Time/ Mode
- Shows left time when workout�
- Shows the target time when being in programming mode�
- Shows program selection when being in program mode�
8
Hz
7�17
7�33
11�83
12�00