Eurocave Compact 59 Serie Mode D'emploi page 33

6 - A
III - Adding sliding shelves
When you purchase your wine cabinet, the
dimensions of the sliding shelves have been
adjusted so that they fit perfectly into the
interior of your cabinet. In the event that you
purchase another sliding shelf, if necessary,
you can adjust it yourself. To do this, loosen
the right and left screws of the first slider
(2 screws), then adjust the slide to the width
required and retighten the screws. Repeat
the procedure for the second slider (if
required):
IV - Modifying the layout of your cabinet
To change the position of a storage shelf, you must first of all unload the shelf, then remove the
shelf supports taking care to reinstall them as shown opposite:
To change the position of a sliding shelf, you must first of all completely unload it. Then lift out the sliding tray by sliding it forwards whilst at the same time
lifting it from the front. Find the runner guides on the left and right and remove. Then reinstall them in the new position as shown below:
Wall
Guide
Wall
Guide
Then replace the sliding drawer as shown opposite:
7 - C
OMMISSIONING YOUR WINE CABINET
1- Connecting up your wine cabinet
Make check that your socket has a power supply (presence off fuses and amperages, and that there is an
operational 30 mA circuit breaker*).
* Not applied to certain countries.
Having waited for 48 hours, switch on your wine cabinet at the main power supply.
II- Switching on the cabinet
Press on the internal and standby button and then release. A start-up message flashes for 5 seconds before the cabinet's temperature is displayed.
At the time of switching on, if the set temperature is less than the ambient temperature, the blue cold circuit indicator will light up.
If the set temperature is higher than the ambient temperature, the red hot circuit indicator will light up.
To put your cabinet in standby, press on the
RRANGEMENT AND STORAGE
Adjusting screw
Slider
Setting up the rear part
of the guide
Sliding shelf
Guide
button for 5 seconds.
Slider
Slider
Shelf
support
Setting up the front part
of the guide
Guide
Wall
Adjusting screw
Wall
Wall
Guide
14
EN