Eurocave Compact 59 Serie Mode D'emploi page 31

5 - I
• Remove th logo support (14) (Fig.h).
Fig. h
- Gently press the "EuroCave" logo (18) to loosen it from the logo support
(14) (Fig. 1)
- Rotate the logo (18) 180° before repositioning it on the logo support
(14) (Fig. 1).
Fig. i
• To turn the door
- Turn the door through 180°
!!! WARNING: the glazed doors are very heavy. Take all necessary
precautions not to injure yourself or drop the door. Never place it on its
edges, which may break it.
• To replace the logo and the lock
- Replace the logo support (14) (Figs. g and h).
- Replace the lock with the slot vertical and pointing downwards(Fig. j).
Fig. j
- Tighten the plastic nut (16) first by hand as far as possible, then with a 28
spanner (a) (provided in the accessories bag) maximum 1/2 turn of the
spanner)
- Attach the cam (13) to the end of the lock (12) with the screw (17) and
with a TX20 Torx spanner supplied in the accessories bag (Figs. k and e)
!!! WARNING note the direction of rotation of the cam (13): it must
always turn upwards (whether the door is mounted on the right or left
side).
Fig. k
NSTALLING YOUR WINE CABINET
(only for solid door)
!!! WARNING: for safety reasons, the key has a double action: it must be
pressed and turned at the same time (Fig. l)
Fig.l
• To replace the door
- Reposition the door vertically on its axis (7) not forgetting the washer
(9) (Fig. m).
9
7
Fig. m
• Reattach the hinge (1) with the screws (3) so that the door is parallel
with the cabinet (Fig. n).
• Check that the seal adheres to the cabinet (by closing the door), to make
it airtight.
!!! WARNING: maintain the distance X between the door and the cabinet
(X = 11 mm for the glazed door of the small model and X = 10 mm for all
other models).
• Insert the plugs (2) and (5) (Fig. n).
Fig. n
12
EN