Publicité
Les langues disponibles
Les langues disponibles
5 - I
• Adjusting the mounting feet and attachment (only when the cabinet is empty)
- The 4 feet of the wine cabinet
are adjustable in height so that the
height below the work surface or
in the unit can be adjusted, and to
align the door with adjacent
furniture (Fig. 8).
- Use the correct screws to secure the wine cabinet under the work
surface or in the unit through the holes provided in the hinges.
Never obstruct the front ventilation grille which would impair the
operation of the wine cabinet (Fig. 10).
Precautions : on the side of the axis of rotation of the door, position
the latter a minimum of 3 mm from adjacent furniture.
The mains power socket must be accessible after installation of the unit.
For medium and large models, it is essential to secure the cabinet to the wall to prevent it from tipping forward. Have your cabinet
checked by a professional to confirm that it is fixed to the furniture and that the furniture is fixed to the wall.
Attachment of a furniture door with a technical door:
- Position the cabinet level under the work surface or in the furniture.
- Open the cabinet door 90
o
.
- Fix the facing of the kitchen furniture to the cabinet door (8 screws supplied).
- Check that the seal is airtight.
Installing a cabinet within a high level kitchen unit
For safety reasons, we do not advise installing the wine cabinet in a kitchen
unit.
If this is the case, check with a furniture specialist that the unit supporting
the equipment and the surrounding furniture can support the weight of the
cabinet when filled with full bottles, or 200 kg. Have its stability checked by
this specialist when opening the door and removing shelves loaded with full
bottles.
NSTALLING YOUR WINE CABINET
Fig. 8
- If necessary, use the hexagonal
pillars (8) (Fig. 9) that you will find
in the "accessories" bag. Tilt the
unit forward, taking care to keep
the door closed.
Unscrew the rear feet and install
the pillars, using a 17 mm flat
spanner.
Screw the 2 rear feet back onto
the pillars.
Repeat these operations for the 2
front feet, taking good care to tilt
the unit backwards.
Do not
obstruct
Fig. 10
Fig. 9
10
EN
Publicité
