Eurocave Compact 59 Serie Mode D'emploi page 26

5 - I
I - In General
- On unpacking you wine cabinet after delivery, check for any obvious exterior damage (dents, malformation, etc.).
Open the door and check that the inside of the appliance is complete and in good condition (walls, shelves, hinges,
control panel, etc.).
- In the event of a problem, contact your dealer.
- Move your wine cabinet to your selected location. This position must be:
- away from any heat source,
- not too wet (wash room, utility room, bathroom, etc.),
- be on a flat solid floor,
- have an electrical power supply (standard 16A plug connected to a 30 mA circuit breaker*).
* not applied to certain countries
- Never place your wine cabinet in a location liable to flooding.
- Avoid splashing water onto the base of the appliance.
- Place the clay humidity cassette (for 1 temperature models only), which you will find inside your cabinet's
"accessories" box) in the receptacle provided for it beneath the grid located at the base of the cabinet (see diagram
page 19). When using the cassette for the first time, please soak the cassette for ten minutes in water, and let it drain.
- Take the power lead (which you will find inside your cabinet's "accessories" box) and connect it to the socket
provided at the rear bottom left of the cabinet. (see the two opposite diagrams)
- Unwind the power supply lead so that it can be accessed.
- Place the power supply lead so that it is not in contact with any of the appliance's components.
- IMPORTANT - Wait 48 hours before switching on to allow the fluids contained in the internal circuits to
settle.
- Adjust the 4 feet of the cabinet (by screwing in or out), so that your wine cabinet stands perfectly level (we
recommend using a spirit level).
- Never obstruct the front ventilation grille.
- Remove the protective packing inside the cabinet.
- Install the carbon filter, which you will find inside your cabinet's "accessories" box , by placing it in the air circulation
hole located inside the cabinet on the top left hand side (see diagram opposite).
- Never connect several wine cabinets to a multi-socket and do not use an extension cord.
- BEWARE: any changing of the control panel LED should only be carried out by a qualified electrician.
- For medium and large models, if the wine cabinet is not being built in, it is essential to secure it to the wall to
prevent it from tipping forward.
You will find all the necessary parts in the accessories bag supplied with the unit.
For installation (see diagram below):
1 - Loosen the screws (2),
2- Attach the bracket (1) to the cabinet with the screws (2),
3- Clip the nut (3) to this bracket (preferably choose the hole nearest to the cabinet),
WARNING: make sure that the part is correctly clipped by pulling upwards by hand. The clip must not come out
4- Preposition the wall bracket (1') (on the nut (3) to determine the position for drilling the holes for the wall-mounting screws,
5- Drill the holes then attach the wall bracket (1') with (4) suitable screws,
WARNING: ensure that the wall fixing can withstand a tensile force of 100 kg
6- Tighten screw (6) with the washer (5) until it is screwed fully in and there is contact between the wall bracket (1') and the nut (3).
Only full tightening of the screw will ensure correct fixing of the unit.
Repeat the installation on the other side of the cabinet.
N.B.: when moving your wine cabinet, do not incline it more than 45°, and always toward
side where the power lead is located.
7
NSTALLING YOUR WINE CABINET
1 - fixing bracket (x2)
1' - wall fixing bracket (x2)
2 – screw for fixing to cabinet (x4)
3 – clipped nut (x2)
4 - screw to suit wall fixing (not supplied) (x4)
5 - washer (x2)
6 - fixing screw (x2)