Abus TVIP40000 Manuel Utilisateur page 94

11. Camera tampering detection
The video server supports tampering detection. If detection is enabled, the alarm can be used as an event for
a notification (see "Application").
"Enable video server tampering detection" The sensor system is activated.
"Triggering behaviour" The period defines how long a tampering event must continue before an alarm
is triggered.
The following tampering events are checked:

Camera rotation

Camera masking

Camera defocussing
You can set tampering detection as a trigger in the camera function "Application/Event setup".
12. Camera control
The video server includes an option for analogue PTZ camera control.
RS485 Settings
"Disable" RS485 control is switched off.
"PTZ camera" Here, enter the relevant parameters for the PTZ camera. The following protocols are
supported: Pelco-D, Pelco-P, Samsung scc643, DynaDome/SmartDOME, Lilin PIH-7x00.
If none of these protocols are supported by your PTZ camera, select "Custom camera".
"Transparent HTTP Tunnel" If your PTZ device supports RS485 commands via a network interface, you can
select this option. Refer to the operating manual of your PTZ device for the necessary parameters.
94
English