Configuration; Preparation - Multiplex LiPo-Saver 60A 2 6S Série Notice D'utilisation

5. Configuration

The simplest and most convenient method of
configuring the LiPo SAVER 2...6S sensor is to use
the MULTIPLEX Launcher PC program.
GB
You will find the Launcher software in the Download
area of www.multiplex-rc.de; a MULTIPLEX USB lead
(Order No.: 8 5149) is also required.

Preparation:

· Disconnect the sensor lead (c) from the receiver
socket, and connect it to the USB PC lead. You can
use the Y-lead which is supplied with the USB lead.
· Now start MULTIPLEX Launcher.
· Connect a four-cell NiMH receiver battery to the
vacant socket of the Y-lead. Launcher should now
automatically detect the sensor. If this does not
happen, you will need to select the appropriate port
manually in the 'COM-Port' field.
Once the sensor is correctly recognised, the PC screen
will display the current software and hardware infor-
mation. You can now click on the symbols to select the
various settings, make your changes, and store the
settings.
18
Key to the symbols in the menu bar:
General information
General settings
Telemetry settings
Firmware update
Save changes
Please Note: Every time you make a change, the
arrow symbol switches to orange. Click on the symbol
to save the setting to the sensor.
Once you have completed all the settings and saved
them, you can quit MULTIPLEX Launcher, and
disconnect the sensor and battery.
The LiPo SAVER 2...6S sensor is now ready for use
with the new settings.