Configuration - Multiplex TEK-Vario+TAS Sensor Notice D'utilisation

5. Configuration

The simplest and most convenient method of
D
configuring the TEK-Vario + TAS sensor is to use
EN
the MULTIPLEX Launcher PC program.
You will find the Launcher software in the Download
area of www.multiplex-rc.de; a MULTIPLEX USB lead
(Order No.: 8 5149) is also required.
Preparation:
· Disconnect the sensor lead (d) from the receiver
socket, and connect it to the USB PC lead. You can
use the Y-lead which is supplied with the USB lead.
· Now start MULTIPLEX Launcher.
· Connect a four-cell NiMH receiver battery to the va-
cant socket of the Y-lead. Launcher should now au-
tomatically detect the sensor. If this does not happen,
you will need to select the appropriate port manually
in the 'COM-Port' field.
Once the sensor is correctly recognised, the PC screen
will display the current software and hardware infor-
mation. You can now click on the symbols to select the
various settings, make your changes, and store the
settings.
16
Key to the symbols in the menu bar:
General information
General settings
Telemetry settings
Firmware update
Save changes
Every time you make a change, the arrow symbol
switches to orange. Click on the symbol to save the
setting to the sensor.
Once you have completed all the settings and saved
them, you can quit MULTIPLEX
Launcher, and disconnect the sensor and battery.
The TEK-Vario + TAS sensor is now ready for use with
the new settings.