Haojue NK150 2020 Mode D'emploi page 99

Oil level check
(A)UPPER LEVEL (B)LOWER LEVEL
Inspect the engine oil level following the steps below.
1. Stop the engine and support it on a flat ground with
the help of the side stand.
2. Start the engine and have it run for several minutes.
3. After the engine has been stopped for several minutes.
4. Remove the engine oil dipstick, wipe it, when the
motorcycle is held upright, insert it into the engine
oil without turning it and then take it out to check
the engine oil level. The engine oil level should be
between the UPPER LEVEL and LOWER LEVEL on
the engine oil dipstick.
BCAUTION
If the engine oil level is lower than the LOWER
LEVEL on the engine oil dipstick, do not start
the engine. When adding engine oil makes sure
the engine oil level is not higher than the UPPER
LEVEL.
Haojue NK150 99011H40002H000 V02 ES+EN+FR 2020-1-17
Engine oil change
Replace the engine oil with new oil after the engine is in a
hot state to completely drain the original engine oil. Steps
for engine oil replacement.
1. Stop the engine and support it on flat ground with the
help of the stand.
2. Remove the engine oil dipstick 1.
3. Place a drain pan below the engine. Dismantle the
drain plug 2 and its washer to drain the original
engine oil.
4. After draining all the engine oil, install the drain plug
2 and its washer.
5. Fill 1000 milliliter of new engine oil into the engine via
the oil filling port of the dipstick.
6. Install engine oil the dipstick again 1.
7. Start the engine and have it run for several minutes.
8. Stop the engine and inspect the engine oil with
the dipstick several minutes later.
level should be between the UPPER LEVEL and the
LOWER LEVEL.
36
Haojue NK150 99011H40002H000 V02 ES+EN+FR 2020-1-17
(99)
EN
The engine oil
(99)