Haojue NK150 2020 Mode D'emploi page 106

(106) Haojue NK150 99011H40002H000 V02 ES+EN+FR 2020-1-17
wheel.
When adjusting the free stroke 1 of the rear brake pedal,
set the pedal at a comfortable position, adjust the pedal
by rotating the pedal limiting bolt 2 and then rotate the
adjusting nut 3. Turn it clockwise for a smaller free stroke,
or anticlockwise for a larger one. Make the free stroke 1
20–30mm.
NOTE: If follow the steps, the free stoke is not required,
please have it checked by the authorized dealer.
Wear limit of rear brake
There is a wear limit mark on
the rear brake of the motorcycle.
Inspect the wear situation of the
rear brake following the essentials
below.
1. Inspect whether the braking
system has been
EN
adjusted.
2. Operate the braking system and inspect and make
sure the mark extending line 1 is in the allowed range
3 (see the figure) marked on the wear limit mark
2, otherwise have the component in the rear brake
replaced by a qualified distribution and maintenance
organization for safety.
(106) Haojue NK150 99011H40002H000 V02 ES+EN+FR 2020-1-17
The mark
extending line is in
properly
the allowed range
BWARNING
Riding with worn brake shoes will reduce braking
performance and will increase your chance of
having an accident.
before each use. Ask your Haojue dealer or a
qualified mechanic to replace brake shoes if the
shoes are worn to the limit.
TIRES
Periodic checks should be performed for tire pressure
and tire wear status. To ensure maximum safety and
life, check the tire frequently, in addition to the scheduled
inspections.
BWARNING
Tire pressure and wear status are very important
for the performance and safety of the motorcycle.
Be sure to check tire pressure and tire wear status
regularly.
Tire pressure
Under normal temperature, test the tire pressure by using
a tire pressure gauge, set the pressure base on the
pressure value recommended by this manual.
pressure is too high or too low, it will affect ride stability,
and will cause the tire to wear.
43
Inspect brake shoe wear
If the