Haojue NK150 2020 Mode D'emploi page 76

(76) Haojue NK150 99011H40002H000 V02 ES+EN+FR 2020-1-17
OVERTAKING SWITCH 2 :
Press the switch to flash the headlight.
CLUTCH LEVER 3
The clutch lever is used for disengaging the drive to the
rear wheel when starting the engine or shifting gears.
Grasping the lever disengages the clutch.
NOTE: The clutch lever provided with a clutch switch.
Electric start can be realized smoothly when the clutch
lever is firmly grasped.
HORN BUTTON 4 ,
Pressing this button will trigger the horn.
TURNING SIGNAL SWITCH 5 = 8
Moving the switch to the "=" position will engage the
left turn signals. Moving the switch to the "8" position
will engage the right turn signals. The indicator on the
dashboard will also flash. To cancel turn signal operation,
push the switch inward.
EN
BWARNING
Failure to use and failure to turn off the turn signals
can be hazardous Other drivers may misjudge your
course and this may result in an accident. Always
use the turn signals when you intend to change
lanes or make a turn. Be sure to turn off the turn
signals after completing the turn or lane change.
(76) Haojue NK150 99011H40002H000 V02 ES+EN+FR 2020-1-17
RIGHT HANDLE SWITCHES
Accelerate
ELECTRIC STARTUP BUTTON 1 #
This button is used for operating the starting motor. With
the ignition switch at the "*" position and the transmission
in neutral, grasp the clutch lever and push the electric
starter button # to operate the starter motor to start the
engine.
BWARNING
Engaging the starter motor for more than five
seconds at a time can damage the start motor and
wiring harness from overheating.
Do not engage the starter motor for more than five
seconds at a time. If the engine does not start after
several attempts, check the fuel supply and ignition
system. Refer to the "TROUBLESHOOTING"
section in this manual.
BWARNING
When cleaning the motorcycle, do not clean
its electric parts with the high-pressure water,
particularly its handle switch.
13