Publicité
Les langues disponibles
Les langues disponibles
Control Pro 250 M
The HEA Filter Set keeps nozzle blockages to a minimum (see "HEA Filter Set").
i
HEA Filter Set
Assembly
The gun and high-pressure hose must be de-pressurised before
the ilter set is installed / removed.
Danger
1. Disconnect the high-pressure hose from the gun (1).
2. If necessary, screw on the ilter housing (2) and insert a ilter (3) appropriate
to the nozzle (the conical side (A) must point upwards).
Nozzle 311
Filter red
Nozzle 517 / 619 Filter white (pre-installed in the ilter housing)
3. Screw the ilter housing (2) to the gun (1).
4. Screw the high-pressure hose (4) irmly to the ilter housing (2).
Cleaning
The gun and high-pressure hose must be de-pressurised before
the ilter set is installed / removed.
Danger
1. Remove the ilter housing (2) from the hose (4) and the gun (1).
2. Screw on the ilter housing (2) and remove the ilter (3).
3. Thoroughly clean the ilter (3) and ilter housing (2) (if worn, replace the ilter).
4. During reassembly, take care not to lose the seal and spring.
Interruption of Work
Be sure to follow the Pressure Relief Procedure when shutting the unit of for any purpose.
This procedure relieves the pressure from the spray hose and the gun.
Danger
•
Switch the device of (pressure regulator in position 0) and remove the power plug.
•
Put the spray gun in a plastic bag and seal so that it is air-tight.
•
Wet paint surface in paint container with a little water to prevent a skin from forming.
Taking Out of Operation and Cleaning
Proper cleaning is the prerequisite for problem-free operation of the paint application device. No warranty claims are accepted
in case of improper or no cleaning.
Do not use lammable materials / cellulose thinner for cleaning purposes.
Danger
Always clean the device as soon as you have inished operation.
i
Dried-on coating substance makes cleaning more diicult.
1. Perform Pressure Relief Procedure.
2. Secure the spray gun.
3. Remove the nozzle holder from the spray gun. (Fig. 19)
4. Put the suction hose and return low pipe into a container full of water or suitable cleaning solution.
5. Turn the switch to the SPRAY position and set maximum pressure.
6. Hold the spray gun on the edge of the paint container. (Fig. 20)
Ground gun with a metal container if lushing with solvent.
Danger
2
4
GB
1
A
3
2 3
Publicité
