EUROM TH1800R Manuel D'utilisation page 16

Installation
 Remove all package material and check the appliance, supply cord and the plug
for signs of damage.
 Pay attention to the mounting place for your heater. The appliance has to be
mounted on an incombustible foundation. That foundation has to be vibration
free, exact vertical and stable enough for lastingly holding the appliance free of
problems. Check or the provided mounting materials are suitable, strong enough
and qualified for the foundation. The material provided is identified for a brick
foundation; for another foundation please ask the specialist for suitable material.
Mounting at a wall
 Check before mounting or the minimum safe mounting distances between heater
and environment are strictly followed. The distance between the bottom edge of
the appliance and the floor must be at least 1,8 meter. There must be a distance
of at least 0,5 meter between the appliance and the sidewalls and between
appliance and ceiling, roof or other cover. If the covers consist of flammable
material (for example wood, plaster, canvas etc.), the distance has to be at least
1 meter and if you focus the radiator upwards, at least 1,8 meter. When you
install the appliance outside, pay attention that it doesn't catch excessive wind
load.
 Fix the mounting bracket
totally horizontal on the
wall with the four anchor
dowels provided. The short
side of the bracket has to
point upwards (see fig. 1).
 See diagram
diagram 'Description'
the materials to be used
(ring, spring washer and
nut).
 Fasten the
bracket to the radiator. To
do this, slide the bracket over the fastening point of the radiator (see diagram 2),
hole with screw thread over hole with screw thread. Insert the bolt (Philips head)
first through the holes without a screw thread, and then through the holes with a
screw thread. Now screw them as tightly as possible. Secure the screw at the
thread end with the locking nut. Now tighten this firmly.
 Slide the radiator with the suspension bracket as far as possible into the wall
bracket, in such a way that the ON/OFF switch is at the bottom. The holes for the
fastening screws are now completely aligned. Insert both of the fastening screws
(with black cap) first through the wall bracket and then through the suspension
bracket and screw them together firmly.
1 and
for
suspension
16