Télécharger Imprimer la page

Husqvarna WR 250 2010 Livret D'utilisation Et D'entretien page 85

Masquer les pouces Voir aussi pour WR 250 2010:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

TRANSMISSION OIL LEVEL CHECKING
By keeping the motorcycle on a flat surface and in vertical posi-
tion, remove the control screw (C), and check the level through
the hole in the screw.
Note*: Have this operation made with war-
med-up engine.
A: Draining plug
B: Filling cap
C: Levelling screw
TRANSMISSION OIL CHANGE
To completely replace the oil, unscrew the plug (A) under the
oil sump and let oil come out, then screw the plug again with
its gasket and pour fresh oil from the hole of the loading plug.
Use only the prescribed quantity and type of oil (see on page
8)
Note:
Have this operation made with warmed-up
engine.
A: Draining plug
COOLANT LEVEL CHECK
Check level (1) in right-hand radiator when engine is cold
(place the motorcycle so that it is perpendicular to the
ground). The coolant should be approximately 10 mm above
cells.
The radiator cap is provided of two unlocking positions, the
first being for the previous pressure discharge in the cooling
system.
WARNING
Avoid removing radiator cap when engine is
hot, as coolant may spout out and cause
scalding.
NOTE
Difficulties may arise in eliminating coolant
from varnished surfaces. If this occurs,
wash off with water.
1
19

Publicité

loading

Ce manuel est également adapté pour:

Wr 300 2010Wr 250 2010 usaWr 300 2010 usa